Cisco TelePresence IX5200 최초 설정 - 페이지 8

{카테고리_이름} Cisco TelePresence IX5200에 대한 최초 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence IX5200 40 페이지.
Cisco TelePresence IX5200에 대해서도 마찬가지입니다: 빠른 시작 사용 설명서 (15 페이지), 사용자 설명서 (26 페이지), 설치 매뉴얼 (36 페이지)

페이지 인쇄

Powering on the System and Enabling the Cisco TelePresence Administration Software GUI

Remove the bottom fascia by using the following procedure:

While two people make this procedure easier, only one person is required.

Note

Turn on the two PDUs mounted on the lower left and lower right display frames.

After you turn on the codecs, the IX5000 display codec becomes active. The system displays white

check marks on the center display to show bootup progress. Bootup is complete when the system

completes all check marks as show in

If you have not registered the system to Unified CM, make a note of the MAC address that appears during

Tip

the bootup process. The MAC address is required to register the system to Unified CM.

Cisco TelePresence IX5000 and IX5200 First-Time Setup

While wearing gloves, grasp the fascia from the left side at the top corner and pull it outward.

Let the fascia swing outward from its hinge.

Set the left side of the fascia on the ground, leaving it upright. Do not twist or put undue stress

on the joints.

Move to the center of the system, pull the center of the fascia outward, and set that part on the

ground.

Take the right end of the fascia at the upper corner, pull it outward, and set that on the ground.

Leave the center and side sections at slight angles so that it remains upright.

Figure

OL-27038-01