Cisco TelePresence IX5200 İlk Kez Kurulum - Sayfa 8
Konferans Sistemi Cisco TelePresence IX5200 için çevrimiçi göz atın veya pdf İlk Kez Kurulum indirin. Cisco TelePresence IX5200 40 sayfaları.
Ayrıca Cisco TelePresence IX5200 için: Hızlı Başlangıç Kullanım Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (26 sayfalar), Kurulum Kılavuzu (36 sayfalar)
Sayfayı Yazdır
Powering on the System and Enabling the Cisco TelePresence Administration Software GUI
Remove the bottom fascia by using the following procedure:
a.
While two people make this procedure easier, only one person is required.
Note
1.
2.
3.
4.
b.
Turn on the two PDUs mounted on the lower left and lower right display frames.
After you turn on the codecs, the IX5000 display codec becomes active. The system displays white
check marks on the center display to show bootup progress. Bootup is complete when the system
completes all check marks as show in
If you have not registered the system to Unified CM, make a note of the MAC address that appears during
Tip
the bootup process. The MAC address is required to register the system to Unified CM.
Cisco TelePresence IX5000 and IX5200 First-Time Setup
8
While wearing gloves, grasp the fascia from the left side at the top corner and pull it outward.
Let the fascia swing outward from its hinge.
Set the left side of the fascia on the ground, leaving it upright. Do not twist or put undue stress
on the joints.
Move to the center of the system, pull the center of the fascia outward, and set that part on the
ground.
Take the right end of the fascia at the upper corner, pull it outward, and set that on the ground.
Leave the center and side sections at slight angles so that it remains upright.
Figure
2.
OL-27038-01