Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installatie Opmerking - Pagina 13

Blader online of download pdf Installatie Opmerking voor {categorie_naam} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 pagina's. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ook voor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installatie Opmerking (14 pagina's), Oplossingshandleiding (17 pagina's), Installatie Opmerking (46 pagina's), Witboek (19 pagina's), Beschrijving (1 pagina's), Product Bulletin (6 pagina's), Kennisgeving (4 pagina's), Gegevensblad (9 pagina's), Gegevensblad (18 pagina's), Witboek (18 pagina's), Configuratiehandleiding (8 pagina's), Installatie Opmerking (28 pagina's), Handleiding voor probleemoplossing (11 pagina's), Installatie Opmerking (18 pagina's), Gebruikershandleiding (17 pagina's), Handmatig (19 pagina's), Installatie Opmerking (36 pagina's)

Pagina afdrukken
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installatie Opmerking
Figure 3
Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create
c.
a small (0.040 inch [1 mm]) gap between the module's EMI gasket and the module above it. (See
Figure
Pressing down too firmly on the levers will bend and damage them.
Caution
While pressing down, simultaneously close the left and right ejector levers to fully seat the
d.
supervisor engine or module in the backplane connector. The ejector levers are fully closed when
they are flush with the module faceplate. (See
78-15751-01
Clearing the EMI Gasket in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
WS-X6K-SU P2-2GE
2
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
3
Press down
4
WS-X622 4
5
24 PORT 100FX
6
3
4
4
WS -C6 500 -SF
M
5
5
SW ITC H FAB IRD
MD L
6
6
3.)
Catalyst 6500 Series Switch Content Switching Module Installation Note
Switch
Load
100%
PORT 1
PCMCIA
EJECT
1%
Switch
Load
100%
PORT 1
PCMCIA
EJECT
1%
1 mm
Gap between the module
EMI gasket and the
module above it
Figure
4.)
Installing the CSM
PORT 2
PORT 2
Press down
13