Argo DRY NATURE 13 Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo DRY NATURE 13. Argo DRY NATURE 13 12 pagina's.

Remove the tank and safely connect the hose to the continuous condensate discharge connection, as shown in the

figures below.

The height of the drainage hose must not exceed that of the hole: do not block the drainage hose exit.

BUTTONS AND LED INDICATORS

(1) POWER BUTTON

Press this button to turn the dehumidifier on and off.

(2) SETTINGS BUTTON

Press this button to set the desired humidity level in the room. The unit can be set from 40% to 80% at 5% intervals.

When the humidity level in the room is lower by 2% than the selected humidity the compressor will stop working and

fans will stop 3 minutes later. When environment humidity is equal to or higher than the selected humidity by 2%,

compressor will restart.

(3) HIGH/LOW BUTTON

Press this button to select the fan velocity, high or low.

(4) TIMER/TEMPERATURE DISPLAY

In normal operation this display will show the environment temperature.

(5) HUMIDITY DISPLAY

The environment humidity is shown on this display.

If the humidity level is lower to 35% this display shows 35. If the humidity is above 95% the display shows 95.

(6) TIMER BUTTON

When the unit is not operating: press this button to set the delay time of switching on (from 1 to 24h later). When

the unit is operating press this button to set the delay time of switching off (from 1 to 24h later).

(7) TANK FULL LED

When the tank is full or not correctly positioned, the unit will sound a beep lasting approximately 15": then the LED

will turn on and the unit stops working. The LED will turn off once the tank is emptied and/or properly repositioned.

V 01/19

CONTROL PANEL