Cisco ASA 5585-X Onderhoudshandleiding - Pagina 10
Blader online of download pdf Onderhoudshandleiding voor {categorie_naam} Cisco ASA 5585-X. Cisco ASA 5585-X 44 pagina's. Maintenance and upgrade procedures
Ook voor Cisco ASA 5585-X: Snelstarthandleiding (40 pagina's), Snelstarthandleiding (6 pagina's)
Pagina afdrukken
Installing and Removing Cisco ASA 5585-X Network I/O Modules
Figure 4-7
2
1
4- or 8-port 10-G network module
3
Slot 2 left bay
Figure 4-8
1
2
1
20-port 1-G network I/O module
3
Slot 2 left bay
Step 6
Slide the network module into the slot until it is seated and push the ejection levers back into place.
Step 7
With your fingers, tighten the captive thumb screws.
If you are installing only one network I/O module, install a slot cover on the empty slot bay to protect it.
Step 8
Caution
You must install slot covers on all empty slots to maintain the proper air flow. This also prevents EMI,
which can disrupt other equipment.
Install a SFP/SFP+ transceiver by aligning it with the I/O module port and sliding it into the port slot
Step 9
until it locks into position
Do not remove the optical port plugs from the SFP/SFP+ until you are ready to connect the cabling.
Caution
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
4-10
Installing a 4- or 8-Port 10-G Network I/O Module
SF P1
SF P0
7
6
5
4
3
1
2
Installing a 20-Port 1-G Network I/O Module
SF P1
SF P0
7
6
5
4
3
2
(Figure
2
1
0
0
1
MG MT
0
1
US B
3
AU X
4
2
Ejection levers
4
Slot 1 right bay
2
1
0
0
1
MG MT
0
1
US B
3
AU X
4
2
Ejection levers
4
Slot 1 right bay
4-9).
Chapter 4
Maintenance and Upgrade Procedures
CO NS OL
RE SE T
E
CO NS OL
RE SE T
E
OL-22567-02