Cisco SCE 1000 and Snelstarthandleiding - Pagina 6

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco SCE 1000 and. Cisco SCE 1000 and 49 pagina's. Service control engine 1000 2xgbe

Pagina afdrukken

Installing the Crossrail Supports (Four-post rack only)

This section provides information for assembling the crossrail supports and attaching them to the rack.

When mounting in a rack with four posts (front and back) the two crossrail supports are mounted one on each side of the rack.

The SCE 1000 then slides into these crossrails, which support the weight of the unit.

• Assemble the Crossrail Supports, page 6

• Attach the Crossrail Supports to the Rack, page 6

Assemble the Crossrail Supports

Assemble the two crossrail supports. Use three screws for each crossrail assembly.

Step 1

Figure 6

Assembling the Slider Brackets

Make sure that they are oriented so that both crossrails will support the SCE 1000 when they are attached to the rack.

Step 2

Attach the Crossrail Supports to the Rack

Align the crossrail supports with the side of the rack, parallel to the floor.

Step 1

Figure 7

Attaching the Crossrails to the Rack

Insert and tighten two screws to the front posts or mounting strips of the rack

Step 2

Insert and tighten two screws to the Back posts of the rack.

Step 3

Repeat steps 2 and 3 on the other side of the rack, keeping the brackets flush against the posts and parallel to the

Step 4

supporting bracket on first side of the rack.