Epson Stylus Scan 2000 Snel aan de slag - Pagina 2

Blader online of download pdf Snel aan de slag voor {categorie_naam} Epson Stylus Scan 2000. Epson Stylus Scan 2000 4 pagina's. Scanning application force quits on mac os 10.4 release of twain pro driver 2.10a;
Ook voor Epson Stylus Scan 2000: Gebruikershandleiding (7 pagina's), Productinformatieblad (4 pagina's), Handleiding productinformatie (13 pagina's), Productinformatieblad (4 pagina's), Product ondersteunings bulletin (12 pagina's), Specificatie (2 pagina's), Handmatig (11 pagina's), Product ondersteunings bulletin (3 pagina's), Product ondersteunings bulletin (14 pagina's), Handmatig (35 pagina's), Gebruikershandleiding (24 pagina's), Online handleiding (10 pagina's)

Pagina afdrukken
Epson Stylus Scan 2000 Snel aan de slag
Install the ink cartridges (continued)
Then press the clamp down
until it snaps into place.
The
ink out light goes off.
8. Lift up the clamp.
Then press
the clamp
down until it
snaps into
place.
Charging takes about 2 minutes. The
makes various sounds. Don't turn off the printer yet. Wait until the
light stops flashing and stays on.
Don't open the clamps to remove a cartridge except to
CAUTION
replace it with a new one. Once you remove a cartridge,
you can't reuse it, even if it contains ink. You must install both cartridges and
leave them installed for all types of printing. To avoid damaging the printer,
never move the print head by hand.
6.Insert the color ink
cartridge as shown.
7. Press the
cleaning
button. The print head
moves to the left so you
can install the black ink
cartridge.
9. Insert the black
cartridge as
shown.
10. Press the
cleaning
button to begin charging the
ink delivery system. Then
close the front cover.
power light flashes and the printer
power
5

Load paper

1. Slide out the
edge guide.
2. Slide out the
tray extensions.
4. Make sure the paper
fits under the arrow mark
inside the edge guide.
Slide the guide against
the paper.
6
Test your
EPSON Stylus Scan
1. Turn off the printer.
2. Hold down the
When you release the buttons, the nozzle check page starts to print. This is
what it should look like:
If it doesn't look right, you may need to run a print head cleaning cycle. See
your User's Guide for instructions. If it doesn't print, see "Solving Problems" in
your User's Guide.
o o v v e e r r
turn
3. Place the stack of
paper against the
right side of the
feeder.
load/eject button.
3. Press the
power
button.