CRU Forensic Labdock S5 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CRU Forensic Labdock S5. CRU Forensic Labdock S5 10 pagina's.

Forensic LabDock S5 and U5 User Manual

2.3.3 SAS Hard Drives (Available only on S5 models)

a. Insert the hard drive into the cubby. Face the power and data connection side outward.

b. Attach the included SATA data/power connector to the rear of the drive.

c. Connect the 4-pin power cable on the SATA data/power connector to the power port on the front of

the Forensic LabDock.

d. Connect the eSATA data cable of the SATA data/power connector to the "SAS Pass Thru" port above

the 4-pin legacy Molex power port on the front of the Forensic LabDock.

e. Flip the power switch to the 1 position to power the Forensic LabDock on.

a. Plug the device into the "USB WriteBlocker" port on the front of the Forensic LabDock.

b. If the device has an On/Off switch, turn it on.

c. Flip the power switch to the 1 position to power the Forensic LabDock on.

NOTE

If the computer fails to recognize the thumb drive, cycle the thumb drive's power (but removing and

reinserting it or switching it off and on again) and then press the Remount button.

This feature is useful for previewing the contents of a USB drive enclosure to determine if it contains

digital evidence that you need to acquire. If it does, you can then decide whether to acquire the evi-

dence through the USB connection or to open the drive enclosure and attach the bare hard drive to the

Forensic LabDock with an IDE or SATA write-blocked connection.

Supported USB drive enclosures have the following characteristics:

• Are seen as a single physical device by your computer's OS

• Are powered by an AC adapter or an extra USB bus power cable

Connect the drive enclosure to the Forensic LabDock's "USB WriteBlocker" port with a USB cable and

power the enclosure on. Then flip the power switch on the Forensic LabDock to the 1 position to power

the Forensic LabDock on.

Compatible SATA and PATA drive adapters are available that allow the Forensic LabDock to access to

2.5" PATA/IDE, Hitachi 1.8-inch, Toshiba 1.8-inch, MacBook Air 2010, mSATA, PCIe PATA, PCIe SATA, or

PCIe USB drives.

a. Connect the drive to the adapter.

b. Attach the included 4-pin legacy Molex power cable to the adapter and the other end to the front of

the Forensic LabDock.

c. Connect the appropriate SATA or IDE cable to the drive adapter and the other end to the Forensic

LabDock.

d. Flip the power switch to the 1 position to power the Forensic LabDock on.

Protecting Your Digital Assets