Pioneer DEH-P8400BH Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Pioneer DEH-P8400BH. Pioneer DEH-P8400BH 39 pagina's. Cd rds receiver
Pagina afdrukken
Section
Operating this unit
02
Removing the front panel to protect your unit from
theft
1 Press the detach button to release the front
panel.
2 Push the front panel upward (M) and then pull
it toward (N) you.
3 Always keep the detached front panel in a pro-
tection device such as a protection case.
Re-attaching the front panel
1 Slide the front panel to the left.
Make sure to insert the tabs on the left side of
the head unit into the slots on the front panel.
2 Press the right side of the front panel until it is
firmly seated.
If you cannot attach the front panel to the
head unit successfully, make sure that you are
placing the front panel onto the head unit cor-
rectly. Forcing the front panel into place may
result in damage to the front panel or head
unit.
Turning the unit on
1 Press SRC/OFF to turn the unit on.
Turning the unit off
1 Press and hold SRC/OFF until the unit turns
off.
6
En
Selecting a source
1 Press SRC/OFF to cycle between:
XM (XM tuner)—SIRIUS (SIRIUS tuner)—
TUNER (tuner)—CD (CD player)—USB (USB
storage device)/iPod (iPod connected using
USB input)—Pandora (Pandora)—EXT (exter-
nal unit 1)—EXT (external unit 2)—AUX1
(AUX1)—AUX2 (AUX2)—BT Audio (BT audio)
—TEL (BT telephone)
Adjusting the volume
1 Turn M.C. to adjust the volume.
CAUTION
For safety reasons, park your vehicle when re-
moving the front panel.
Notes
! When this unit's blue/white lead is con-
nected to the vehicle's auto-antenna relay
control terminal, the vehicle's antenna ex-
tends when this unit's source is turned on.
To retract the antenna, turn the source off.
! If plug and play is on and either an iPhone or
iPod touch is connected, it may take time for
your source to switch. Refer to
USB plug&play (plug and play) on page 15.
! TEL (BT telephone) is available on DEH-
P7400HD only when a Bluetooth adapter (e.
g. CD-BTB200) is connected to the unit.
Operating this unit
Use and care of the remote
control
Using the remote control
1 Point the remote control in the direction of the
front panel to operate.
When using for the first time, pull out the film
protruding from the tray.
Replacing the battery
1 Slide the tray out on the back of the remote
control.
2 Insert the battery with the plus (+) and minus
(–) poles aligned properly.
WARNING
! Keep the battery out of the reach of children.
Should the battery be swallowed, consult a
doctor immediately.
! Batteries (battery pack or batteries installed)
must not be exposed to excessive heat such
as sunshine, fire or the like.
CAUTION
! Use one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is
not used for a month or longer.
! There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic ob-
jects.
! If the battery leaks, wipe the remote control
completely clean and install a new battery.
! When disposing of used batteries, comply
with governmental regulations or environ-
mental public institutions' rules that apply in
your country/area.
! "Perchlorate Material – special handling may
apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate. (Applicable to California,
U.S.A.)"
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! The remote control may not function properly
in direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under
the brake or accelerator pedal.
Menu operations identical
for function settings/audio
adjustments/initial settings/
lists
Returning to the previous display
Returning to the previous list/category. (the folder/
category one level higher.)
1 Press
/DISP.
Turning the demo display on or off
1 Press and hold
/DISP.
Returning to the ordinary display
Canceling the initial setting menu
1 Press BAND/ .
Returning to the ordinary display from the list/cat-
egory
1 Press BAND/ .
Selecting a function or list
1 Turn M.C. or LEVER.
! In this manual, "Turn M.C." is used to describe
the operation used to select a function or list.