Pioneer A-107 Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Pioneer A-107. Pioneer A-107 12 pagina's. Stereo
Ook voor Pioneer A-107: Servicehandleiding (8 pagina's), Gebruiksaanwijzing (13 pagina's)

Pagina afdrukken

OPERATIONS

BEFORE BEGINNING OPERATIONS

1. Set the VOLUME control to minimum.

2. Set the POWER switch to ON.

3. Press the SPEAKERS switch to ON.

4. Set the BALANCE control to the center position.

5. Set the DIRECT button to off.

6. Set the TAPE 2 MONITOR button to off.

PLAYBACK PROCEDURES

1. Set the INPUT SELECTOR knob to the desired

playback source.

÷ For playback of a compact disc: Set to [CD].

÷ For reception of an AM/FM broadcast: Set to [TUNER].

÷ For playback of a record: Set to [PHONO].

÷ For playback with the equipment connected to the LINE

terminals: Set to [LINE].

÷ For playback of a tape: Set to [TAPE 1/MD].

NOTES:

÷ When you do not want to monitor the TAPE 2 MONITOR

sound, set the PATE 2 MONITOR button to OFF.

÷ When you select PHONO, the sound is muted for a few

seconds.

2. Operate the equipment to begin playback.

3. Adjust playback volume with the VOLUME con-

trol on this unit.

4. Adjust the tone to your preference using the

BASS and TREBLE controls, and LOUDNESS but-

ton.

RECORDING TAPES

1. Select the recording equipment with the INPUT

SELECTOR knob.

2. Begin recording by operating the recording equip-

ment and cassette deck.

Refer to the operating instructions of your cassette deck

for proper operating procedures.

COPYING TAPES

When two decks are used, you can record the sounds from

one deck onto the other.

Application examples:

÷ To make a tape copy with contents identical to the original

tape.

÷ To edit a recording of an FM broadcast in order to cut out

unwanted commercials, recording only of desired material

onto another tape.

1. Load tapes for playback (pre-recorded tape) and

recording (blank tape) into the respective cas-

sette decks.

2. Select the copying direction with the INPUT SE-

LECTOR knob and TAPE 2 MONITOR button.

÷ When copying from the cassette deck of the TAPE 1/

MD terminals to the cassette deck of the TAPE 2

MONITOR terminals: Set the INPUT SELECTOR knob

to TAPE 1/MD.

÷ When copying from the cassette deck of the TAPE 2

MONITOR terminals to the cassette deck of TAPE 1/

MD terminals: Set the TAPE 2 MONITOR button to ON

and the INPUT SELECTOR knob to a position other than

TAPE 1/MD.

3. Operate the cassette decks to begin copying.

Set the cassette deck with the original (playback) tape to

the playback mode, and set the cassette deck with the

blank tape to the recording mode.