Pioneer SX-2600 Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Pioneer SX-2600. Pioneer SX-2600 16 pagina's. Stereo control amplifier
Ook voor Pioneer SX-2600: Gebruiksaanwijzing (28 pagina's), Schematisch diagram (4 pagina's)

Pagina afdrukken

FRONT PANEL FACILITIES

@ FM TUNING AUTO/MANUAL switch

Works during FM reception.

@@ DIRECT ACCESS tuning switch

When this switch is pressed, the STATION CALL switches function as

ten-key number

switches

for direct input of the desired reception

frequency.

Press again to cancel this mode.

!f the input station falis outside of the receiver's tuning range, the display

section will display a message: ''UPPER"' if the frequency is toa high

and "LOWER" if it is too low (see page 9).

@&: GRAPHIC EQUALIZER controls

The equalizer is divided into five frequency ranges {100 Hz, 330 Hz,

1 kHz, 3.3 kHz, 10 kHz} to tailor music to the individual taste of the

listener

dé CUSTOM

MEMORY

switches

Stations can be assigned to STATION CALL switches according to the

genre of material broadcast (ROCK, POP, OTHER).

You can recall a

particular genre, and scan all the stations of that genre with Memory

Scan unit you reach the desired one

@) OPERATION DISPLAY pane!

{a) Indicates the function or frequency by the function switches,

{b} TUNED indicator

{c) FM STEREO indicator

id) FM MONO indicator

(e) TUNING AUTO/MANUAL indicator

{f} DIRECT ACCESS tuning indicator

{g) SIMULATED

STEREO indicator (SX-2600 only)

(th) CUSTOM

MEMORY

indicator

fi) Indicates channel or STATION CALL number,

{j) SCAN indicator

(k) MEMORY

indicator

{i} TAPE

2 monitor indicator

{a}

'amin WA WA WAL ig) kA

sane 2]

emi

aM TAAL

UN te

828"

{b) —{3URZ57]

| OURECTS.

costar]

BATION

access/]|

memory

! ce [om

(c)

(stesed']

Stor

BIMULATED

id}

px mono | imanuaL

BYERES

rit : ch

| i

fg)

(h}

(igs) TUNING

switches (DOWN,

UP)

UP: The FM or AM

band is scanned in the direction of increasing

frequency.

DOWN: The opposite operation to that of the UP switch takes place.

This turns monaural signals into simulated stereo sound. Use this when

you

wish

to experience

the sense

of stereo

presence

with

broadcasts, VCR or other monaural signal sources.

NOTE:

This function can be used' with stereo sources, but it will result in a

different sound from the normal stereo sound.

* Before operating the unit, be sure to set it as shown below.

Set the VOLUME control

to the ''0"' position.

Press the SPEAKERS switch TE

corresponding to the speaker

system to be used.

to the center position.

Set the TAPE 2 MONITOR

switch to OFF

{TAPE 2 indicator goes off).