Pioneer SX-2600 Kullanım Talimatları Kılavuzu - Sayfa 7
Amplifikatör Pioneer SX-2600 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer SX-2600 16 sayfaları. Stereo control amplifier
Ayrıca Pioneer SX-2600 için: Kullanım Talimatları Kılavuzu (28 sayfalar), Şematik Diyagram (4 sayfalar)
Sayfayı Yazdır
FRONT PANEL FACILITIES
@ FM TUNING AUTO/MANUAL switch
Works during FM reception.
@@ DIRECT ACCESS tuning switch
When this switch is pressed, the STATION CALL switches function as
ten-key number
switches
for direct input of the desired reception
frequency.
Press again to cancel this mode.
!f the input station falis outside of the receiver's tuning range, the display
section will display a message: ''UPPER"' if the frequency is toa high
and "LOWER" if it is too low (see page 9).
@&: GRAPHIC EQUALIZER controls
The equalizer is divided into five frequency ranges {100 Hz, 330 Hz,
1 kHz, 3.3 kHz, 10 kHz} to tailor music to the individual taste of the
listener
dé CUSTOM
MEMORY
switches
Stations can be assigned to STATION CALL switches according to the
genre of material broadcast (ROCK, POP, OTHER).
You can recall a
particular genre, and scan all the stations of that genre with Memory
Scan unit you reach the desired one
@) OPERATION DISPLAY pane!
{a) Indicates the function or frequency by the function switches,
{b} TUNED indicator
{c) FM STEREO indicator
id) FM MONO indicator
(e) TUNING AUTO/MANUAL indicator
{f} DIRECT ACCESS tuning indicator
{g) SIMULATED
STEREO indicator (SX-2600 only)
(th) CUSTOM
MEMORY
indicator
fi) Indicates channel or STATION CALL number,
{j) SCAN indicator
(k) MEMORY
indicator
{i} TAPE
2 monitor indicator
{a}
|
'amin WA WA WAL ig) kA
sane 2]
emi
aM TAAL
UN te
828"
{b) —{3URZ57]
| OURECTS.
costar]
BATION
access/]|
memory
! ce [om
(c)
(stesed']
Stor
BIMULATED
id}
px mono | imanuaL
BYERES
rit : ch
| i
fg)
(h}
u
(igs) TUNING
switches (DOWN,
UP)
UP: The FM or AM
band is scanned in the direction of increasing
frequency.
DOWN: The opposite operation to that of the UP switch takes place.
This turns monaural signals into simulated stereo sound. Use this when
you
wish
to experience
the sense
of stereo
presence
with
AM
broadcasts, VCR or other monaural signal sources.
NOTE:
This function can be used' with stereo sources, but it will result in a
different sound from the normal stereo sound.
* Before operating the unit, be sure to set it as shown below.
Set the VOLUME control
to the ''0"' position.
Press the SPEAKERS switch TE
corresponding to the speaker
system to be used.
to the center position.
Set the TAPE 2 MONITOR
switch to OFF
{TAPE 2 indicator goes off).
7
<ARBI214>