Ariston Margherita 2000 Handleiding voor installatie en gebruik - Pagina 20
Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Ariston Margherita 2000. Ariston Margherita 2000 45 pagina's. Front-loading washing machine
Ook voor Ariston Margherita 2000: Handleiding voor installatie en gebruik (17 pagina's)
![Ariston Margherita 2000 Handleiding voor installatie en gebruik](/uploads/products/server2/663281/663281.jpg)
M
ARGHERITA
2000
Here Im in command
Making the right choice is important. And its easy.
Programme selector knob
and programmed start
It is used to select the wash
programme.
Before setting anything, press
the on/off button (L). Lamp M
will begin to flash.
The chosen programme is visible
through the window O.
Remember that the knob can
only be turned in a clockwise
direction.
To select the programmes, make
sure the mark situated on
window O is aligned with the
symbol/number corresponding to
the desired programme for at
least 5 seconds. After these 5
seconds, the setting is accepted,
lamp M stops flashing (staying
lit) and the wash cycle begins. If
you want to interrupt the
programme in progress or to set
a new one, select one of the
symbols (Stop/Reset) and wait
for 5 seconds: when the
cancellation has been accepted,
lamp M will flash.
You can use this knob to delay
the washing machines operation:
select one of the four positions
for programmed start and wait for
5 seconds. This is when the
setting has been accepted (lamp
M stops flashing and stays lit)
and you can select the
programme you require.
Pilot lamp M has a particular
flashing action (2 seconds lit and
4 seconds off) to indicate that the
delayed start has been set.
During this phase, it is possible
to open the door and modify the
washing load.
After the wash cycle has been set
and accepted by the washing
machine, turning the knob will
have no effect (except for when
it is on position Stop/Reset).
The detergent dispenser with
the additional bleach
compartment is here.
17
Margherita 2000 - Instructions for installation and use
Margherita 2000s knobs are hidden.
Just press them lightly in the middle
to extract them.
Temperature control knob
It is used to set the wash tempe-
rature in the recommended
programme table on pag. 18. It
also allows you to reduce the tem-
perature recommended for the
selected programme, and even to
set a cold wash cycle ( ).
Spin exclusion knob
It is used to exclude the spin
cycle (by choosing symbol ) or
to reduce the spin speed of the
selected programme. The
maximum speed for the four
types of fabric are:
Fabric
Speed
Cotton
1200 rpm
Synthetics 800 rpm
Wool
600 rpm
Silk
no
Note: distribution phase will be
carried out at low speed.
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
The washing machine is
equipped with an extra
compartment 4 (provided as an
accessory) for the bleach, to be
inserted in compartment 1.
4
1
2
3
Understanding the control panel
E
F
D
Programme key
This contains the descriptions of
the wash programmes and the
various functions connected to
the buttons. Pull it outwards to
open it.
Rinse hold
This button allows you to
interrupt a programme (on
symbol ) keeping the washing
soaking in water before the spin
cycle. It is a very useful button
in particular because it can be
used for delicates and synthetics.
It is only to be used with wash
program-mes for synthetic
fabrics, silk and curtains when it
is impossible for you to take the
washing out immediately. Before
opening the washing machine
door, finish the wash cycle as
follows:
Silk and curtains: press button
F and Margherita 2000 will drain
the water.
Synthetic fabrics: press button F
if you want a spin cycle, or turn
knob A to symbol
want the water to be drained.
Rapid wash
This button reduces the length of
the wash programme by about
30%. It cannot be used with
special programmes (see page 18)
or those for wool and silk.
Stain removal (see page 21)
Thanks to this command, Mar-
gherita 2000 will carry out a more
intensive wash that optimises the
effectiveness of the liquid
additives, thus allowing more
resistant stains to be removed.
G
I
L
H
N
M
O
C
B
When you press the stain removal
button, you cannot activate the
pre-wash cycle (I).
Prewash
With this button, you can pre-
wash on all programmes except
the wool programme and the
special programmes (see page
18). If you use this function, you
cannot use the stain removal
button (H).
On-off
When button L is pressed, the
washing machine is switched on,
when it is not the machine is
switched off.
Turning the appliance off does
not cancel the selected
programme.
The on-off lamp
Lamp M flashes when the
appliance is switched on and
awaiting a programme to be set.
A steady light means the
if you
appliance has accepted the
selected programme.
The door block lamp
The safety lamp indicates that the
washing machine door is locked
to prevent it from being opened
accidentally. To avoid any
damages to lock mechanism, you
must wait for the lamp to
extinguish, before attempting to
open the door which takes
around three minutes.
A