Ariston Margherita 2000 Kurulum ve Kullanım Kılavuzu için Talimatlar - Sayfa 20

Yıkayıcı Ariston Margherita 2000 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu için Talimatlar indirin. Ariston Margherita 2000 45 sayfaları. Front-loading washing machine
Ayrıca Ariston Margherita 2000 için: Kurulum ve Kullanım Kılavuzu için Talimatlar (17 sayfalar)

Sayfayı Yazdır

ARGHERITA

2000

Here Im in command

Making the right choice is important. And its easy.

Programme selector knob

and programmed start

It is used to select the wash

programme.

Before setting anything, press

the on/off button (L). Lamp M

will begin to flash.

The chosen programme is visible

through the window O.

Remember that the knob can

only be turned in a clockwise

direction.

To select the programmes, make

sure the mark situated on

window O is aligned with the

symbol/number corresponding to

the desired programme for at

least 5 seconds. After these 5

seconds, the setting is accepted,

lamp M stops flashing (staying

lit) and the wash cycle begins. If

you want to interrupt the

programme in progress or to set

a new one, select one of the

symbols (Stop/Reset) and wait

for 5 seconds: when the

cancellation has been accepted,

lamp M will flash.

You can use this knob to delay

the washing machines operation:

select one of the four positions

for programmed start and wait for

5 seconds. This is when the

setting has been accepted (lamp

M stops flashing and stays lit)

and you can select the

programme you require.

Pilot lamp M has a particular

flashing action (2 seconds lit and

4 seconds off) to indicate that the

delayed start has been set.

During this phase, it is possible

to open the door and modify the

washing load.

After the wash cycle has been set

and accepted by the washing

machine, turning the knob will

have no effect (except for when

it is on position Stop/Reset).

The detergent dispenser with

the additional bleach

compartment is here.

Margherita 2000 - Instructions for installation and use

Margherita 2000s knobs are hidden.

Just press them lightly in the middle

to extract them.

Temperature control knob

It is used to set the wash tempe-

rature in the recommended

programme table on pag. 18. It

also allows you to reduce the tem-

perature recommended for the

selected programme, and even to

set a cold wash cycle ( ).

Spin exclusion knob

It is used to exclude the spin

cycle (by choosing symbol ) or

to reduce the spin speed of the

selected programme. The

maximum speed for the four

types of fabric are:

Fabric

Speed

Cotton

1200 rpm

Synthetics 800 rpm

Wool

600 rpm

Silk

Note: distribution phase will be

carried out at low speed.

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-wash;

2. Detergent for the main cycle

wash;

3. Fabric conditioner.

The washing machine is

equipped with an extra

compartment 4 (provided as an

accessory) for the bleach, to be

inserted in compartment 1.

Understanding the control panel

Programme key

This contains the descriptions of

the wash programmes and the

various functions connected to

the buttons. Pull it outwards to

open it.

Rinse hold

This button allows you to

interrupt a programme (on

symbol ) keeping the washing

soaking in water before the spin

cycle. It is a very useful button

in particular because it can be

used for delicates and synthetics.

It is only to be used with wash

program-mes for synthetic

fabrics, silk and curtains when it

is impossible for you to take the

washing out immediately. Before

opening the washing machine

door, finish the wash cycle as

follows:

Silk and curtains: press button

F and Margherita 2000 will drain

the water.

Synthetic fabrics: press button F

if you want a spin cycle, or turn

knob A to symbol

want the water to be drained.

Rapid wash

This button reduces the length of

the wash programme by about

30%. It cannot be used with

special programmes (see page 18)

or those for wool and silk.

Stain removal (see page 21)

Thanks to this command, Mar-

gherita 2000 will carry out a more

intensive wash that optimises the

effectiveness of the liquid

additives, thus allowing more

resistant stains to be removed.

When you press the stain removal

button, you cannot activate the

pre-wash cycle (I).

Prewash

With this button, you can pre-

wash on all programmes except

the wool programme and the

special programmes (see page

18). If you use this function, you

cannot use the stain removal

button (H).

On-off

When button L is pressed, the

washing machine is switched on,

when it is not the machine is

switched off.

Turning the appliance off does

not cancel the selected

programme.

The on-off lamp

Lamp M flashes when the

appliance is switched on and

awaiting a programme to be set.

A steady light means the

if you

appliance has accepted the

selected programme.

The door block lamp

The safety lamp indicates that the

washing machine door is locked

to prevent it from being opened

accidentally. To avoid any

damages to lock mechanism, you

must wait for the lamp to

extinguish, before attempting to

open the door which takes

around three minutes.