Ariston 65 DRY Handmatig - Pagina 33

Blader online of download pdf Handmatig voor {categorie_naam} Ariston 65 DRY. Ariston 65 DRY 41 pagina's.

Pagina afdrukken

PROTECH FUNCTION

The "PROTECH" function activates for the product, an electronic system that protects against corrosion orig-

inateci by the water-metal contact, ensuring excellent longevity of the appliance's tank in case of chemically

aggressive water. The principle of operation is the following: the electronic circuit creates a difference in

potential between the tank and the titanium electrode, thereby guaranteeing excellent protection of the tank,

preventing corrosion due to the galvanic effect. For correct system operation, it is necessary to guarantee the

permanent connection of the product to the electric al power mains. Also in the case of appliance downtime,

turn the product off by the ON/OFF " button, disconnect it from the electrical power mains. lf you wish to

switch the electrical power supply off tor long periods of time, it is advisable to empty out all of the water con-

tained in the appliance (see "Maintenan ce" paragraph) to ensure increased durability of the tank/resistance.

RESET/DIAGNOSTICS

When any of the operation problems occur, the appliance goes into "fault status" and all LEDs on the control

panel will flash simultaneously.

Diagnostics: to enable the diagnostic function, hold the ON/OFF " button button and the "-" button for 5

seconds. The type of fault is indicated by five LEDs according to the following scheme:

LED 40° - internal malfunction of the circuit board

LED 40° - 60° - internal malfunction of the circuit board (NFC communication or NFC data)

LED 60° - broken temperature probes (open or short circuited) - boiler outlet

LED 80° - excessive water temperature detected by single sensor - boiler outlet

LED 70° - 80° - generai excessive water temperature (circuit board fault) - boiler outlet

LED 60° - 70° - Failure to heat water with powered heating element - boiler outlet

LED 60°, 70° e 80° - overheating caused by lack of water - boiler outlet

LED 50° e 60° - broken temperature probes (open or short circuiteci) - boiler inlet

LED 50° e 80° - excessive water temperature detected by single sensor - boiler inlet

LED 50°, 70° e 80° - generai excessive water temperature (circuit board fault) - boiler inlet

LED Rif. 50°, 60° e 70° - failure to heat water with powered heating element - boiler inlet

LED Rif. 50°, 60°, 70° e 80° - overheating caused by lack of water - boiler inlet

Exit the diagnostic function by pressing the ON/OFF " button or wait tor 25 seconds."

WI-FI FUNCTION

For further information about Wi-Fi configuration and the product registration procedure, refer to the

enclosed quick start guide dedicated to connectivity, or visit the website:

https://discover.ariston-net.remotethermo.com

Connection status description

Slow flashing

Wi-Fi

Rapid flashing

Button

Double flashing

OFF

PAIRING BETWEEN THE POWER METER SMART SWITCH AND THE WATER HEATER

After connecting the indoor water heater, check the status of the Wi-Fi Led on the Power Meter Smart Switch,

if it is fixed blue, then you will not need to do any other operation.

Otherwise if the LED is blinking blue, a qualified technician should be called.

The Wi-Fi module is ON

The Wi-Fi module is in Access Point mode

The WI-Fi module is connecting to the home network

The Wi-Fi is ON and connected to the home network

The Wi-Fi module is OFF

33 / EN