Ariston GENUS PREMIUM EVO HP 150 Ontwerp, installatie en onderhoudsinstructies - Pagina 24

Blader online of download pdf Ontwerp, installatie en onderhoudsinstructies voor {categorie_naam} Ariston GENUS PREMIUM EVO HP 150. Ariston GENUS PREMIUM EVO HP 150 44 pagina's. Wall-hung condensing gas boiler hp
Ook voor Ariston GENUS PREMIUM EVO HP 150: Gebruikershandleiding (17 pagina's), Gebruikershandleiding (24 pagina's)

Pagina afdrukken

Ariston GENUS PREMIUM EVO HP 150 Ontwerp, installatie en onderhoudsinstructies

commissioning

First ignition

1. Make sure that:

The gas valve is closed;

The electrical connection has been properly carried out.

Make sure that, in any case, the green/yellow earthing wire

is connected to an effi cient earthing system;

Use a screwdriver to lift the cap on the automatic air relief

valve;

2. Switch on the boiler (by pressing the ON/OFF button) and use

the M

button to select the standby mode, where no hot

ODE

water or heating requests are made.

01/01/2000

40°C

3. Start the deaeration cycle by pressing ESC for 5 seconds

The boiler will start a deaeration cycle lasting about 7 minutes.

If you need to stop it press ESC.

At the end, check that the system is completely deaerated and,

if not, repeat the procedure.

Airpurge attiva

4. Bleed the air from the radiators.

5. Check the pressure gauge reading to verify that there is

suffi cient plant pressure (1-1.5 mbar); if not, the display will

signal the need for re-establishing the pressure.

Re-establish the pressure by opening the water inlet valve

located underneath the boiler.

6. The exhaust duct for combustion products should be suitable

and free from any obstructions;

7. Any necessary ventilation inlets in the room should be open

(type B installation).

8. Check whether the siphon contains water; if not, it must be

refi lled.

N.B.: if the boiler will not be used for long periods, the

siphon should be fi lled before the boiler is started up

again. It is dangerous not to refi ll the siphon as fumes may

be released into the environment.

9. Open the gas valve and check the connection seals, including

the boiler connection seals, making sure that the meter does

not detect any passage of gas. Eliminate any leaks.

10. Start the boiler by selecting the heating or domestic hot water

operation using the M

ODE

00:00

70°C

button.

Deaeration cycle

During the fi lling stage or if there is excess air in the system,

the deaeration cycle can be activated by holding the E

button for 5 seconds. The boiler will start a cycle which lasts

approximately 7 minutes. When this is complete the menu

screen will be restored. The cycle may either be repeated, if

necessary, or stopped by pressing E

until the normal display screen is restored.

. Press the E

button