Ariston A45V Reparatiehandleiding - Pagina 7

Blader online of download pdf Reparatiehandleiding voor {categorie_naam} Ariston A45V. Ariston A45V 11 pagina's.

5. CONTROL PANEL COMPONENTS

• To remove the On / Off Switch and Start Switch (Fig. 5-1) or the LED Indicators (Fig. 5-2) first remove the Control Panel as

described in Section 4. With the Control Panel Mounting Screws removed, angle the Control Panel down to allow access to the

LED Assembly (A) or the Microswitch Assembly (B) (Fig. 5-3). Either component can be replaced by removing the two (2) Phillips

screws that secure the assemblies in place.

TECH NOTE: The On / Off and Start Buttons can be replaced without removing the Control Panel. First mask the area to protect

against damaging the Control Panel, then carefully insert a small screwdriver between the bottom of the Button and

the Control Panel and then carefully pry the Button out and off.

• To remove the Dryness Sensor Module, first remove the Module Cover (A) (Fig. 6-1) by unlatching the two (2) Module Cover

Latches located on the front top and bottom of the Module Housing (Fig. 6-2). Then swing the Module Cover out and off removing it

from its rear hinge. With the Module Cover removed disconnect the wiring and then slide the Module Board out from the Module

Housing by pressing the two (2) Sensor Board Release Latches (Fig. 6-3).

REPAIR MANUAL

Fig. 5-1

Fig. 5-2

Fig. 6-1

Fig. 6-2

A 45 V

Fig. 5-3

Fig. 6-3

Page: 4