Whirlpool WED9051YW Handleiding voor installatie-instructies - Pagina 19

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool WED9051YW. Whirlpool WED9051YW 20 pagina's. Installation guide
Ook voor Whirlpool WED9051YW: Gebruiks- en onderhoudshandleiding (20 pagina's)

Pagina afdrukken

Adjust leveling legs

If dryer is not level, prop up using a wood block, use wrench

to adjust legs up or down, and check again for levelness.

Once legs are level, make sure all four legs are snug against

the ground before adjusting them.

COMPLETE INSTALLATION

CHECKLIST

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Be sure the water faucets are on.

Check for leaks around "Y" connector, faucet, and hoses.

Check dryer's final location. Be sure vent is not crushed

or kinked.

Check that dryer is level. See "Level Dryer."

Remove film on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

Read "Dryer Use" in your "Use and Care Guide."

For power supply cord installation, plug into a grounded

outlet. For direct wire installation, turn on power.

If you live in a hard water area, use of a water softener is

recommended to control the buildup of scale through the

water system in the dryer. Over time, the buildup of lime

scale may clog different parts of the water system, which will

reduce product performance. Excessive scale buildup may

lead to the need for certain part replacement or repair.

Select a Time Dry heated cycle, and start dryer. Do not select

Air Only Temperature setting.

If dryer will not start, check the following:

• Controls are set in a running or "On" position.

• Start button has been pushed firmly.

• Dryer is plugged into an outlet and/or electrical

supply.

• Household fuse is intact and tight, or circuit breaker

has not tripped.

• Dryer door is closed.

This dryer automatically runs an installation diagnostic routine

at the start of its first cycle.

NOTE:

You may notice an odor when dryer is first heated. This

odor is common when heating element is first used. The odor will

go away.

DOOR REVERSAL

If you prefer to reverse the door swing on your dryer:

door reversal kit, Part Number W10277499 is available to order.

For further information, see "Assistance or Service" section in

your "Use and Care Guide."

STACKING WASHER AND DRYER

If you prefer to stack your washer and dryer:

kit, Part Number 8572546 is available to order. For further

information, see "Assistance or Service" section in your

"Use and Care Guide."

TROUBLESHOOTING

See your "Use and Care Guide" for troubleshooting information.

A stack