Whirlpool 27' Job hulp - Pagina 14

Electronic Dry-Miser

This cycle can be used for most loads. Drying time varies according to type of fabric, size of load and

dryness setting.

•

Set the Cycle Selector Control to the desired dryness.

•

Dryness is determined by an electronic moisture sensor system that "feels" the amount of

moisture in the clothes as they pass over a moisture sensor mounted on the grille assembly

at the front of the drum area. When the selected dryness is reached the dryer goes into a timed

COOL DOWN period of approximately 10 minutes.

•

The End-of-Cycle signal sounds once the cycle is complete.

•

The End-of-cycle signal can be turned OFF by pressing the Cycle Signal OFF pad on the

Clean Touch console.

•

The Finish Guard option will tumble the clothes without heat for about 15 seconds every five

minutes until the door is opened and the clothes removed.

•

The Finish Guard option can be turned OFF by pressing the Finish Guard OFF pad on the

Clean Touch console.

This cycle will provide up to 80 minutes of heated drying time.

•

The heating cycle is followed by approximately 10 minutes of COOL DOWN.

•

The End-of-Cycle signal sounds once the cycle is complete.

•

The End-of-cycle signal can be turned OFF by pressing the Cycle Signal OFF pad on the

Clean Touch console.

•

The Tumble Press portion of the Timed Dry Cycle is designed to provide about 15 minutes of

HEATED TUMBLING followed by 10 minutes of COOL DOWN.

SECTION TWO

CONSOLE

TIMER CONTROL

Fig. 6