FirePro FP-08450 Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} FirePro FP-08450. FirePro FP-08450 20 pagina's. Fire detection and activation system

Pagina afdrukken

Reset Function

7.3

To reset the control panel, press and hold Mode Switch 1 until 2 beeps are heard. Following

a reset, the control panel will automatically isolate. To restore the control panel to normal

operation, press Mode Switch 1 and ensure the "Isolated" LED turns off. Note: The control

panel cannot be reset if the activation sequence has been initiated. When the "Discharging"

LED is no longer illuminated, the reset function will become available again.

Test Function

7.4

The control panel includes a test function, enabling the operator to ensure that the control

panel is functioning correctly. To operate the test function, press and hold Mode Switch 1 until

3 beeps are heard. The test function will illuminate all LEDS on the control panel and operate

the internal sounder and any external siren/strobes for 2 seconds, and then return the control

panel to normal operation. The test function does not activate the suppression system.

Note: If any LEDS or siren/strobes do not operate, contact your supplier.

Discharging the Fire System

7.5

To manually discharge the fire system, press and hold both Mode Switch 1 and Mode Switch

2 continuously for 5 seconds. This will immediately operate any installed siren/strobes and

any shutdown relays, to warn any occupants. Manually discharging the fire system should only

performed during commissioning/servicing when the system has been appropriately isolated,

or in case of fire.

Alarm Silence

7.6

To silence the internal sounder and any installed siren/strobes that have operated due to an

alarm condition, press and hold Mode Switch 1 until a 1 beep is heard and the "Isolated" LED

is illuminated. This will also override any installed shutdown relays and allow for operation of

the equipment. Note: Equipment should not be operated until it has been rendered safe by

the appropriate authority. The control panel will remain in an alarm/fault condition until

serviced and reset.

Page | 14