Whirlpool 30 " Eye-Level Gas Range Handleiding voor installatie-instructies - Pagina 7

Replace Oven Door(s)

IMPORTANT: Do not replace the oven door(s) until after the oven

has been installed into the cabinet.

1. Using two hands, grasp side edges of door at the midpoint.

Face the oven cavity.

2. Locate the slots on each side of the oven cavity for the door

hinge locks.

A. Slot in the oven cavity for

door hinge lock

3. At a 45° angle, align door hinges with slots in the lower front

of the oven cavity. Slowly insert door, making sure you

maintain the 45° angle. You will know the door is engaged in

the slot when you feel a slight drop.

4. Lower the oven door to the fully open position. If the oven

door does not open to a full 90 degrees, repeat steps 1-3.

5. Locate the oven door hinge locks in the corners of the oven

door, and rotate the hinge locks toward the oven cavity to the

locked position.

See Step 3 (illustration A) in the "Remove Oven Door(s)"

section for proper locked position.

6. Close the oven door.

7. When the hinges are properly installed and the door closed,

there should be an even gap between the door and the

control panel. If one side of the oven door is hanging lower

than the other, the hinge on that side is not properly installed.

Positioning Oven Feet for Multiple Cabinet

Single Ovens

The positioning of the oven feet allow a single oven to be

installed in a cutout height between 26¹⁵⁄₁₆" (68.4 cm) and 29⁷⁄₁₆"

(74.8 cm). Refer to the following instructions to position the feet

for the size of your cabinet cutout.

Cutout height is between 27⁵⁄₈" (70.2 cm) and 28⁵⁄₈"

(72.7 cm)

The oven feet do not need to be changed. They are positioned

correctly as received.

Go to the "Make Electrical Connection" section.

Cutout Heights