Direct power BH26S3 Veiligheids- en bedieningshandleiding - Pagina 12
Blader online of download pdf Veiligheids- en bedieningshandleiding voor {categorie_naam} Direct power BH26S3. Direct power BH26S3 17 pagina's. 5kg sds plus rotary hammer drill
Pagina afdrukken2. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
3. Always store your power tool in a dry place.
4. Keep the motor ventilation slots clean.
5. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your
power tool.
6. If the supply cord becomes damaged etc.
HANDY HINTS
Always use sharp good quality drill bits and
chisels.The performance of the drill is dependent
on the quality of the bits used.
• Reduce the pressure on the drill bit when it is
about to break through.This will prevent the
drill from jamming.
• When drilling a large hole, first drill a pilot
hole using a smaller drill bit.
• Always apply pressure to your drill bit in a
straight line, and if possible at right angles to
the workpiece.
•
When drilling holes into walls, floors etc.,
always make sure that there are no live electrical
wires, or pipe work in the path of the bit.
•
Always operate your drill using both the
handle and the front handle.
• Never change the operating mode whilst the
drill is running.
• When using the product in the hammer only
mode, or when chiseling masonry, make sure
that you wear safety glasses and protective
gloves.
• Do not apply excessive pressure to the tool
when chiseling. Expressive force does not
speed up the work.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.