Zanussi ZHC72X Bedienings- en installatie-instructies - Pagina 10

Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Zanussi ZHC72X. Zanussi ZHC72X 16 pagina's. Zanussi instructrion manual ventilation hood zhc72x

Zanussi ZHC72X Bedienings- en installatie-instructies
Before assembling the appliance, it is
necessary to take off the anti-grease
grilles.
To remove the first grille, push it towards
the rear of the apparatus by using the
finger points so that it is released (fig.3).
To take it off completely, rotate it on one
side while keeping the other one steady.
3
If installing the appliance in the ducting
mode, connect one of the two discharge
outlets to the external ducting and seal the
other opening with the cap supplied (fig.4).
4
If installing the appliance in the filtering
mode, both discharge outlets must be
blanked off using the caps supplied.
10

INSTALLATION INSTRUCTIONS

Wall Fitting
Fix the telescopic part (A) with some
adhesive tape (W) so that it cannot slip out
(fig. 5).
Fix the lower part to the upper part of the
hood by using the screws supplied (fig. 5).
5
Using the drilling template fit two of the
screw anchors supplied to the wall,
corresponding to holes B (fig. 6). Insert
two of the screws supplied and hook the
hood in place using the holes B at the
back (fig. 6).
Before fully tightening the screws, mark
the position of the two holes C on the wall
with a marking pen. Unhook the hood and
drill the two holes in the marked positions
and insert the screw anchors. Hook the
hood back into place and finally secure it
with the four screws.
Remove the adhesive tape from the
telescopic part and pull it downwards until
it touches the hob.