Califone Spirit 1776 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Califone Spirit 1776. Califone Spirit 1776 9 pagina's. Multimedia player/recorder
Ook voor Califone Spirit 1776: Specificaties (1 pagina's), Gebruikershandleiding (17 pagina's), Gebruiksaanwijzing (12 pagina's), Productcatalogus (8 pagina's)

Pagina afdrukken

Power Supply

Battery Supply

• Open the battery compartment and insert 8 "C" cell batteries.

• Remove the batteries if exhausted or if the unit will not be used for a long period.

• The battery supply is switched off when the set is connected to the main.

• To change over to battery supply, pull the plug out from the AC socket.

Note on Environmental Protection

Do not throw exhausted batteries in the garbage. Hand them over instead to a recycling center or public collection point.

Go to pages 14 & 15 to read about safe listening with headphones.

Radio Operation

Radio Reception

• Set the Function switch to RADIO.

• Turn the tuning button until a radio station with sufficient signal strength is found. Repeat this procedure

until the desired station is reached.

• To tune into a weak station turn the tuning button until the display shows the desired frequency or when the best

reception has been obtained.

• Extend the telescope antenna and adjust for best reception.

• Adjust the sound using the VOLUME and DBBS controls.

• You can connect a stereo headphone with a 3.5mm plug to the jack. Note that inserting the plug automatically

disconnects the speakers.

• Select the wave band using the BAND SELECT selector.

• Tune to a desired radio station using the TUNING control.

• The set is switched off when the Function switch is in the TAPE position and no button is pressed.

Recording from the Radio

• Insert a blank or pre-recorded tape into the cassette compartment.

• Set the Function selector to RADIO.

• Select the wave band using the BAND SELECT switch.

• Tune to desired radio station using the TUNING control.

• Start recording by pressing record of cassette deck.

Compact Disc Operation

Inserting a CD

• Set the Function switch to CD.

• To open the CD compartment, lift the CD door on the edge marked OPEN/CLOSE.

• Insert the AUDIO CD, printed side facing up.

• Close the cover.

• The CD-player scans the contents list of the CD, then the total number of tracks appears on the display.

Playing a CD

• Press PLAY/PAUSE to start playback.

• The display shows the track number.

• Adjust the sound using the VOLUME and DBBS controls.

• For brief interruptions, press PLAY/PAUSE – the " ll " appears on the display.

• To resume playback, press PLAY/PAUSE again.

• To stop playback, press STOP.

– The total number of tracks will then appear on the display.

The CD player also goes to STOP position when:

• If the CD door is opened

• When the end of the CD is reached

• If the Function selector is changed

• If the batteries run down or if the power supply is interrupted.

• To take out the CD, open the CD door by lifting the edge marked OPEN/CLOSE.

• Open the CD door only if the CD-player is in position STOP.

Selecting another track during play

• Press PREVIOUS or NEXT until the desired track number appears in the display.

• The selected track begins to play after PLAY/PAUSE is pressed.

Starting with a particular track

• Press PREVIOUS or NEXT until the required track number appears in the display.

• Press PLAY/PAUSE.

• Play starts from the selected track.

Searching for a passage during a play

• Hold PREVIOUS down to search backwards to the beginning.

• Hold NEXT down to search forwards to the end.

Note:

This function can be described as "audibly" searching for a title. During the search, volume is reduced and returns to its

adjusted level as soon as the button is released.