Clarke 6462080 Handleiding voor bediening en onderhoud - Pagina 11

Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke 6462080. Clarke 6462080 17 pagina's.

GENERAL CARE

Your sander has been designed to operate over a long period of time with a

minimum of maintenance. Continuous satisfactory operation depends upon

proper care.

• Regularly clean the ventilation slots using a soft dry brush or dry cloth.

• Only clean the motor housing using a clean damp cloth. Do not use any

abrasive or solvent-based cleaner.

• A damaged power cable should be replaced by your Clarke dealer or

a qualified electrician.

• The bearings in this sander are sealed for life and require no

maintenance.

TROUBLE SHOOTING

SANDER IS OVERHEATING

This indicates the machine is dirty. Clean the ventilation holes, and blow out

with compressed air or clean with a dry cloth.

Overloading the machine will also cause overheating. Do not apply excessive

pressure.

EXCESSIVE SPARKING OCCURS

This indicates worn brushes. This problem is quickly remedied but you should

consult your CLARKE dealer for parts and advice.

SANDER DOES NOT OPERATE WHEN SWITCHED ON

Check to ensure the fuse is sound and replace if necessary. If the fuse is sound

or blows repeatedly, consult your CLARKE dealer.

THE DUST IS NOT EXTRACTED

Dust bag is full (empty waste bag), dust extractor flue is blocked, this is usually

caused by allowing bag to become too full, (remove and empty bag, also

clear blockage).

ACCESSORIES

A wide range of accessories is available from your nearest CLARKE dealer, for

further information, contact your nearest dealer, or telephone CLARKE

International Sales department on 01992 565300.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]