Clarke 6462080 Handleiding voor bediening en onderhoud - Pagina 10

Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke 6462080. Clarke 6462080 17 pagina's.

• On very uneven surfaces or when removing layers of paint, start with a

coarse grit. On other surfaces, start with a medium grit. In both cases,

gradually change to a fine grit for a smooth finish.

MAINTENANCE

WARNING: MAKE SURE THAT THE BELT SANDER IS SWITCHED OFF AND

DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING ANY

CLEANING OR MAINTENANCE PROCEDURES.

After use clean out any accumulated dust etc. Keep the cooling vents clear. If

the sander should become too hot, run it for 2 minutes without load.

Clean the housing with a soft cloth. Any worn or damaged parts should be

replaced by qualified personnel. Keep the handles clean and free from oil

and grease. Refer to qualified service personnel if internal maintenance is

required.

Always store the belt sander in the carrying case.

1. With a suitable screwdriver, remove the carbon brush caps on either side of

the belt sander.

2. Remove the carbon brush/spring assembly.

3. If the carbon brushes are worn down to 4mm, or less, replace them with

the new brushes (1 spare set supplied).

4. Replace the carbon brush caps and tighten them.

NOTE: Both brushes must be replaced at the same time.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]