Clarke 6462080 Інструкція з експлуатації та технічного обслуговування - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Шліфувальна машина Clarke 6462080. Clarke 6462080 17 сторінок.
Друкувати сторінку
• On very uneven surfaces or when removing layers of paint, start with a
coarse grit. On other surfaces, start with a medium grit. In both cases,
gradually change to a fine grit for a smooth finish.
MAINTENANCE
WARNING: MAKE SURE THAT THE BELT SANDER IS SWITCHED OFF AND
DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING ANY
CLEANING OR MAINTENANCE PROCEDURES.
After use clean out any accumulated dust etc. Keep the cooling vents clear. If
the sander should become too hot, run it for 2 minutes without load.
Clean the housing with a soft cloth. Any worn or damaged parts should be
replaced by qualified personnel. Keep the handles clean and free from oil
and grease. Refer to qualified service personnel if internal maintenance is
required.
Always store the belt sander in the carrying case.
CHANGING THE CARBON BRUSHES
1. With a suitable screwdriver, remove the carbon brush caps on either side of
the belt sander.
2. Remove the carbon brush/spring assembly.
3. If the carbon brushes are worn down to 4mm, or less, replace them with
the new brushes (1 spare set supplied).
4. Replace the carbon brush caps and tighten them.
NOTE: Both brushes must be replaced at the same time.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10