Directed Electronics Xpresskit DBALL Installatiehandleiding - Pagina 9
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Directed Electronics Xpresskit DBALL. Directed Electronics Xpresskit DBALL 14 pagina's. Databus all combo bypass module
Ook voor Directed Electronics Xpresskit DBALL: Installatiehandleiding (14 pagina's)
Pagina afdrukken
Platform: DBALL
Firmware: GM5
Installation Type 6
(+) 12v
(-) Ground
2: Green/Black: Bulb Test Passlock1 Only
3: Green/White: (-) Door Status Output*
4: Red/Black: (-) Trunk Status Output*
IGNITION KEY
Bulb
test
* If applicable - see the Function List.
Not required in D2D mode.
The Mobile Integration Systems
(+) Accessory Output
(+) Ignition 2 Output
(+) Brake Input
Parking Lights
(AC) Tach Input
(-) Trunk Status Input*
(-) Door Status Input*
1
8
9
16
Diagnostic connector
OBDII (connector side view)
2: Purple/Yellow: J1850
13:Red: (+) 12v
14:Black: (-) Ground
5: Violet/White: (AC) Tach Output
8: Violet/Green: R. Code
9: Violet/Brown: R. Code
RF Loop Connector
Programming button
LED
Black or
Orange/Black
Bulb test wire coming
Yellow
White or
from black connector
Red/White
at the ignition switch.
BCM
Vehicle CAN Bus Integration System
Ground
(-) Lock Output*
(-) Unlock Output*
(-) Trunk Release Output
(+) Starter Output
(+) Ignition 1 Output
(-) GWR (Status)
(+) Starter
10: Blue/White: (-) GWR (Status) Input
9: Pink: (+) Ignition Input
8: Violet: (+) Starter Input
3: Red/White: (-)
Trunk Release Input
2: Blue: (-) Unlock Input*
1: Green: (-) Lock Input*
(+)12v
RX
(-) Ground
DBALL
TX
P#: XKD2D65
© 2010 Directed Electronics. All rights reserved.
Rev.: 20101103
Page 9
Hood Switch
(+) 12 V Input