Directed Electronics 3808A Installatiehandleiding - Pagina 8
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Directed Electronics 3808A. Directed Electronics 3808A 18 pagina's. Auto-mate
Pagina afdrukken
4 pin Auxiliary/Pin switch Monitor Harness
BLACK/WHITE
BLUE/BLACK
GRAY
BLUE
BLACK/WHITE (-) 200mA FLEX 2 OUTPUT
From factory this output is used for a dome light supervision relay, this output can be programmed for other
functions (see features programming table/descriptions for options and how to activate with an add-on
security system).
Important! This output is only intended to drive a relay. It cannot be connected directly to a high current
device.
[Optional connection for both configurations]
BLUE/BLACK (-) 200mA FLEX 1 OUTPUT
From factory this output is used for optional progressive unlock, A progressive unlock system unlocks the
driver's door when the unlock button is pressed and unlocks the passenger doors if the unlock button is
pressed again within 15 seconds after unlocking the driver's door. This output can be programmed for other
functions (see features programming table/descriptions for options and how to activate with an add-on
security system).
Important! This output is only intended to drive a relay. It cannot be connected directly to a high current
device.
[Optional connection for both configurations]
GRAY (N/O or N/C) HOOD TRIGGER INPUT
Connect to a wire that changes state when the hood is opened. N/O = rests at ground when the hood is
OPEN, N/C= rests at ground when the hood is CLOSED (see features programming table for options).
[Optional connection for both configurations]
BLUE (-) TRUNK/MUX TRIGGER INPUT
Connect to a wire that goes to ground (-) when the trunk is opened or to the pre-trigger and full trigger
outputs of an optional Directed Electronics dual zone sensor. This wire is also used for sensor shunt when
adding an optional remote start. See diagram below for sensor shunt wiring information.
ALARM MODULE
[Optional connection for both configurations]
8
(-) 200 mA FLEX 2 OUTPUT (DOME LIGHT SUPERVISION)
(-) 200 mA FLEX 1 OUTPUT (2nd UNLOCK)
(N/O or N/C) HOOD TRIGGER INPUT
(-) TRUNK/MUX TRIGGER INPUT
Trunk Pin Input
Flex Output
Ignition Input
To Trunk pin in
vehicle (if used)
(-) Status Output
(-) Activation Input
Ignition Output
REMOTE START
MODULE
© 2012 Directed. All rights reserved.