- ページ 8

セキュリティシステム Directed Electronics 3808AのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics 3808A 18 ページ。 Auto-mate

4 pin Auxiliary/Pin switch Monitor Harness

BLACK/WHITE

BLUE/BLACK

GRAY

BLUE

BLACK/WHITE (-) 200mA FLEX 2 OUTPUT

From factory this output is used for a dome light supervision relay, this output can be programmed for other

functions (see features programming table/descriptions for options and how to activate with an add-on

security system).

Important! This output is only intended to drive a relay. It cannot be connected directly to a high current

device.

[Optional connection for both configurations]

BLUE/BLACK (-) 200mA FLEX 1 OUTPUT

From factory this output is used for optional progressive unlock, A progressive unlock system unlocks the

driver's door when the unlock button is pressed and unlocks the passenger doors if the unlock button is

pressed again within 15 seconds after unlocking the driver's door. This output can be programmed for other

functions (see features programming table/descriptions for options and how to activate with an add-on

security system).

Important! This output is only intended to drive a relay. It cannot be connected directly to a high current

device.

[Optional connection for both configurations]

GRAY (N/O or N/C) HOOD TRIGGER INPUT

Connect to a wire that changes state when the hood is opened. N/O = rests at ground when the hood is

OPEN, N/C= rests at ground when the hood is CLOSED (see features programming table for options).

[Optional connection for both configurations]

BLUE (-) TRUNK/MUX TRIGGER INPUT

Connect to a wire that goes to ground (-) when the trunk is opened or to the pre-trigger and full trigger

outputs of an optional Directed Electronics dual zone sensor. This wire is also used for sensor shunt when

adding an optional remote start. See diagram below for sensor shunt wiring information.

ALARM MODULE

[Optional connection for both configurations]

(-) 200 mA FLEX 2 OUTPUT (DOME LIGHT SUPERVISION)

(-) 200 mA FLEX 1 OUTPUT (2nd UNLOCK)

(N/O or N/C) HOOD TRIGGER INPUT

(-) TRUNK/MUX TRIGGER INPUT

Trunk Pin Input

Flex Output

Ignition Input

To Trunk pin in

vehicle (if used)

(-) Status Output

(-) Activation Input

Ignition Output

REMOTE START

MODULE