CTEK MXS 5.0 CHECK Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} CTEK MXS 5.0 CHECK. CTEK MXS 5.0 CHECK 8 pagina's. Combined battery charger warranty and battery&alternator check
Ook voor CTEK MXS 5.0 CHECK: Handmatig (2 pagina's)

Pagina afdrukken

ERROR LAMP

If the error lamp is lit, check the following:

1. Is the chargers positive lead connected to the bat-

tery's positive pole?

2. Is the charger connected to a 12V battery?

3. Has charging been interrupted in STEP 1, 2 or 5?

Restart the charger by pressing the MODE-button. If charging is

still being interrupted, the battery...

STEP 1: ...is seriously sulphated and may need to be replaced.

STEP 2: ...cannot accept charge and may need to be replaced.

STEP 5: ...cannot keep charge and may need to be replaced.

POWER LAMP

If the power lamp is lit with a:

1. STEAdY LIGHT

The mains cable is connected to the wall socket.

2. FLASHING LIGHT

The charger has entered the energy save mode. This happens if the

charger isn't connected to a battery in 2 minutes.

REAdY TO USE

The table shows the estimated time for an empty battery to reach 80% charge level

BATTERY SIZE (Ah)

2Ah

8Ah

20Ah

60Ah

110Ah

6 • EN

TIME TO 80% CHARGEd

12h

26h

CHARGING STEPS

STEP 1 dESULPHATION

Detects sulphated batteries. Pulsing current and voltage, removes sulphate from the lead

plates of the battery restoring the battery capacity.

STEP 2 SOFT START

Tests if the battery can accept charge. This step prevents charging of a defective battery.

STEP 3 BULK

Charging with maximum current until approximately 80% battery capacity is reached.

STEP 4 ABSORPTION

Charging with declining current to maximize up to 100% battery capacity.

STEP 5 ANALYSE

Tests if the battery can hold charge. Batteries that cannot hold charge may need to be

replaced.

STEP 6 RECONd

Choose the Recond program to add the Recond step to the charging process. During the

Recond step voltage increases to create controlled gassing in the battery. Gassing mixes

the battery acid and returns energy to the battery.

STEP 7 FLOAT

Maintaining the battery voltage at maximum level by providing a constant voltage charge.

STEP 8 PULSE

Maintaining the battery at 95–100% capacity. The charger monitors the battery voltage

and gives a pulse when necessary to keep the battery fully charged.