CTM LYNG microsafe mKomfy 1.8 16R Installatie-instructies Gebruikersinstructies - Pagina 6
Blader online of download pdf Installatie-instructies Gebruikersinstructies voor {categorie_naam} CTM LYNG microsafe mKomfy 1.8 16R. CTM LYNG microsafe mKomfy 1.8 16R 12 pagina's.
Pagina afdrukken
Installation – Socket
The sensor and socket are paired at the factory and ready to install.
If re-pairing is necessary:
Remove at least once battery from the sensor (you can get batteries ready for
the sensor, but DO NOT fit them).
1.
Give the Socket control button a quick press. Yellow LED flashes.
2.
Hold the control button on the sensor in and fit batteries in the sensor.
3.
There are 4 beeps, the blue LED on the socket flashes and the socket
turns off.
4.
Release the control button on the sensor.
The sensor and socket are now paired.
1. Fitting the socket (may
only be carried out by
authorised personnel)
1. Connect and fit the
socket.
2. Connect the cooker
plug to the Cooker
Guard's socket.
3. Check that power
is connected to the
socket.
Status LEDs
Green
lights up
Blue
flashes
Blue +
flash
Green
alternately
Red
flashes
flashes +
Red
beeping
Yellow lights up
Yellow flashes
* emergency mode = all safety functions deactivated. See page 5.
** 1.2 A is the factory default. After calibration, the LED lights up when the new setting is
exceeded (page 11)
If there is no radio communication from the sensor, the plug will shut off after 5 minutes.
6
when socket is ON
when data is received from paired units (e.g. sensor)
1 minute after emergency mode* is activated, and continues
to flash while the product is in emergency mode (12 hours).
if socket overheats – socket is turned OFF
if there is an error, e.g. external switch paired before
sensor
when cooker's electricity consumption exceeds 1.2 A**
in pairing mode
Control button
DO NOT CONNECT!