3D Creations North American P 51 D Mustang Montagehandleiding - Pagina 6
Blader online of download pdf Montagehandleiding voor {categorie_naam} 3D Creations North American P 51 D Mustang. 3D Creations North American P 51 D Mustang 15 pagina's. Paper scale model kit
Pagina afdrukken
Wing Assembly
For the wing assembly you will need to cut out parts # 8 and 10. Before folding the wing
to shape cut out the black dots that lie in the white areas of the wing. An exacto knife
works well for this. To get the correct alignment when folding the wing double them over
aligning the two areas specified in figure 18. While holding the alignment carefully
crease the trailing edge.
Fold the leading edge tab over along the line shown in figure 19. Do not glue it yet.
Open the wing up and thread the landing gear strut through the hole that was cut earlier.
Make sure the correct strut is on the correct wing. After checking to make sure the gear
hangs straight and checking what will be the wheel alignment glue the bottom portion of
the spar to the wing. Next apply glue to the top of the spar and the leading edge tab.
Close up the wing folding the leading edge tab around and attaching it to the underneath
side of the leading edge. Apply glue to the very edge of the wing tip and pinch the edges
together. Figure 20 shows the completed wings with the gear properly installed.
6