3D Creations North American P 51 D Mustang 조립 지침 매뉴얼 - 페이지 6
{카테고리_이름} 3D Creations North American P 51 D Mustang에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Creations North American P 51 D Mustang 15 페이지. Paper scale model kit
페이지 인쇄
Wing Assembly
For the wing assembly you will need to cut out parts # 8 and 10. Before folding the wing
to shape cut out the black dots that lie in the white areas of the wing. An exacto knife
works well for this. To get the correct alignment when folding the wing double them over
aligning the two areas specified in figure 18. While holding the alignment carefully
crease the trailing edge.
Fold the leading edge tab over along the line shown in figure 19. Do not glue it yet.
Open the wing up and thread the landing gear strut through the hole that was cut earlier.
Make sure the correct strut is on the correct wing. After checking to make sure the gear
hangs straight and checking what will be the wheel alignment glue the bottom portion of
the spar to the wing. Next apply glue to the top of the spar and the leading edge tab.
Close up the wing folding the leading edge tab around and attaching it to the underneath
side of the leading edge. Apply glue to the very edge of the wing tip and pinch the edges
together. Figure 20 shows the completed wings with the gear properly installed.
6