3D Creations North American P 51 D Mustang 조립 지침 매뉴얼 - 페이지 5
{카테고리_이름} 3D Creations North American P 51 D Mustang에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Creations North American P 51 D Mustang 15 페이지. Paper scale model kit
페이지 인쇄
Parts #9 are to be glued down flat to cardboard and then cut to shape.
Part #9 is not
necessary if you are not going to build the kit with landing gear.
Sandwich the landing
gear strut between two of the wing spars (part #9) as shown in figure 17. Make sure that
the two spar edges are matched up evenly and the struts hang at a 90-degree angle from
them. Bad alignment of these parts will cause the landing gear to hang crookedly beneath
the wings.
5