3D Creations North American P 51 D Mustang Montaj Talimatları Kılavuzu - Sayfa 5
Oyuncak 3D Creations North American P 51 D Mustang için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. 3D Creations North American P 51 D Mustang 15 sayfaları. Paper scale model kit
Sayfayı Yazdır
Parts #9 are to be glued down flat to cardboard and then cut to shape.
Part #9 is not
necessary if you are not going to build the kit with landing gear.
Sandwich the landing
gear strut between two of the wing spars (part #9) as shown in figure 17. Make sure that
the two spar edges are matched up evenly and the struts hang at a 90-degree angle from
them. Bad alignment of these parts will cause the landing gear to hang crookedly beneath
the wings.
5