3D Hobby Shop SLICK 540 Montagehandleiding - Pagina 13

Blader online of download pdf Montagehandleiding voor {categorie_naam} 3D Hobby Shop SLICK 540. 3D Hobby Shop SLICK 540 19 pagina's.

When attaching the servo connectors to the arm, do not tighten the nut fully, but leave it a bit loose so the

connectors can rotate freely. Use a drop of CA glue on the nut to prevent it from loosening in flight.

Start by attaching the cables to the pull-wire end on the rudder end. Crimp well, preferably by making

creases in the crimp tube with a sharp pliers or cutters, rather than smashing it completely flat. Apply a

drop of thin ca to the completed crimp to prevent it from sliding on the cable.

The cables cross over each other to form an X inside the fuselage before they reach the rudder servo.