3D Hobby Shop SLICK 540 Montaj Kılavuzu - Sayfa 13

Oyuncak 3D Hobby Shop SLICK 540 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 3D Hobby Shop SLICK 540 19 sayfaları.

When attaching the servo connectors to the arm, do not tighten the nut fully, but leave it a bit loose so the

connectors can rotate freely. Use a drop of CA glue on the nut to prevent it from loosening in flight.

Start by attaching the cables to the pull-wire end on the rudder end. Crimp well, preferably by making

creases in the crimp tube with a sharp pliers or cutters, rather than smashing it completely flat. Apply a

drop of thin ca to the completed crimp to prevent it from sliding on the cable.

The cables cross over each other to form an X inside the fuselage before they reach the rudder servo.