Dispense-Rite SLR-STRAW-2 Installatie- en bedieningsinstructies
Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Dispense-Rite SLR-STRAW-2. Dispense-Rite SLR-STRAW-2 2 pagina's.
Pagina afdrukkenDISPENSE-RITE
INSTALLATION & OPERATION INSTRUCTIONS
The straw dispenser is shipped completely assembled but it will require in-counter installation prior to initial usage.
Important note: This product is shipped configured for use with standard length drinking straws (approximately 8.5" L).
If you are using a jumbo length straw you may need to reverse the orientation of the plunger inside the dispenser to
accommodate longer straws. See SECTION TWO - JUMBO LENGTH STRAWS for details.
SECTION ONE - STRAW DISPENSER INSTALLATION
1
Cut a 5-1/4" diameter hole into the mounting surface.
2
Turn the cover ring counterclockwise to remove from
dispenser.
3
Insert the dispenser into the mounting hole.
Push dispenser all the way in until it is flush with the
counter and align the "UP" mark to the top.
5-1/4"
134 mm
Diversified Metal Products, Inc.
2205 Carlson Drive • Northbrook, IL 60062 • (847) 753-9595 • fax (847) 753-9648
www.dispense-rite.com • [email protected]
SLR-STRAW-2
®
4
Drill four 9/64" pilot holes in the locations shown below.
Fasten the dispenser with the four #10 screws provided.
5
Place cover ring on the mounting head and rotate
clockwise to secure.