3D Systems Cubify CUBEX Trio Vervangingshandleiding - Pagina 10
Blader online of download pdf Vervangingshandleiding voor {categorie_naam} 3D Systems Cubify CUBEX Trio. 3D Systems Cubify CUBEX Trio 13 pagina's. Print jet replacement manual
Pagina afdrukken
Levelling the print tips for CubeX Duo/Trio
If your CubeX only has a single print jet please see section 'Fastening the print
tip on a CubeX'
1. Power on the CubeX printer
2. To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode.
Heat all of the print jets EXCEPT for the new one to 230° and clean of any
plastic debris with pliers. Allow the Print Jets to cool down.
3. Put the CubeX printer into manual move mode.
4. Raise the print pad until it is approximately 5mm away from the print tips.
10