3D Systems PROJET 3500 Procedurehandleiding - Pagina 7
Blader online of download pdf Procedurehandleiding voor {categorie_naam} 3D Systems PROJET 3500. 3D Systems PROJET 3500 7 pagina's. Visijet m3 black material hygiene
Pagina afdrukkenSTEP 5:
If the test print does not look good as
described (See photo):
Repeat Steps 1-3 to perform another
•
Test Print.
STEP 6:
If after three (3) Test Print attempts, the
build does not pass:
Contact your 3D Systems Service
•
Personnel who will provide you with
advanced troubleshooting
procedures.
The Test Print will quickly clear out any potentially clogged jets with minimal material usage.
Please use this procedure when printing with VisiJet® M3 Black AFTER each build.
VisiJet® M3 Black Printhead Hygiene
Example of a Bad Test Print
Notice the blank areas. This represents jets
•
that are partially or fully clogged or missing.