3D Systems ProJet 5500X Snelstarthandleiding - Pagina 12
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 3D Systems ProJet 5500X. 3D Systems ProJet 5500X 13 pagina's.
Pagina afdrukken8/11/22, 10:07 AM
NOTE: If the printer is to be used within 7 to 10 days of the last build, it is
recommended to leave your printer in either standby or conserve mode, instead of
powering off the printer.
If the printer is
than
36
hours, it enters
are partially cooled and many other components are disabled. It takes much less time for
the printer to warm up from
shutdown/power off, (see table below). To increase or decrease wait time before the printer
enters
Standby
Mode
Standby
Conserve
Initial Power Up
Printer Shutdown and Power Off
NOTE: Before shutdown and power off, verify that there is no need to build parts again
soon.
CAUTION: Switching off or disconnecting the printer's power without performing the
following shutdown procedure can damage the printer. Always perform the shutdown
procedure before switching off the printer power unless an immediate power off is
necessary for safety reasons.
1. Verify printer is not building.
2. Press
Tools
3. Press
Printer Shutdown
4. The touchscreen displays
5. The touchscreen displays
. The touchscreen displays
7. After the PC switches off, switch the power switch on the back to the printer to OFF.
infocenter.3dsystems.com/projetmjp5500x/print/book/export/html/966
idle
more than
4
hours, it enters
Conserve
mode. In these energy-saving states, the printer heaters
Standby
mode or
Conserve
mode, contact 3D Systems Technical Support
(A)
(B).
SHUTDOWN MODELER?:
Windows
Shutdown in Progress
Quick Start Guide
Standby
mode. If the printer is idle more
or
Conserve
mode than it does from full
Time
15 min.
25 min.
165 min.
Y/N. Press Yes.
Shutdown:
Please Wait
12/13