3D Systems ProJet 5500X 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} 3D Systems ProJet 5500X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems ProJet 5500X 13 페이지.

페이지 인쇄

8/11/22, 10:07 AM

NOTE: If the printer is to be used within 7 to 10 days of the last build, it is

recommended to leave your printer in either standby or conserve mode, instead of

powering off the printer.

If the printer is

than

hours, it enters

are partially cooled and many other components are disabled. It takes much less time for

the printer to warm up from

shutdown/power off, (see table below). To increase or decrease wait time before the printer

enters

Standby

Mode

Standby

Conserve

Initial Power Up

Printer Shutdown and Power Off

NOTE: Before shutdown and power off, verify that there is no need to build parts again

soon.

CAUTION: Switching off or disconnecting the printer's power without performing the

following shutdown procedure can damage the printer. Always perform the shutdown

procedure before switching off the printer power unless an immediate power off is

necessary for safety reasons.

1. Verify printer is not building.

2. Press

Tools

3. Press

Printer Shutdown

4. The touchscreen displays

5. The touchscreen displays

. The touchscreen displays

7. After the PC switches off, switch the power switch on the back to the printer to OFF.

infocenter.3dsystems.com/projetmjp5500x/print/book/export/html/966

idle

more than

hours, it enters

Conserve

mode. In these energy-saving states, the printer heaters

Standby

mode or

Conserve

mode, contact 3D Systems Technical Support

(A)

(B).

SHUTDOWN MODELER?:

Windows

Shutdown in Progress

Quick Start Guide

Standby

mode. If the printer is idle more

Conserve

mode than it does from full

Time

15 min.

25 min.

165 min.

Y/N. Press Yes.

Shutdown:

Please Wait

12/13