3D Systems ProJet 5500X 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} 3D Systems ProJet 5500X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems ProJet 5500X 13 페이지.

8/11/22, 10:07 AM

Place the platform in a freezer for ten to fteen minutes. As the parts and platform cool, they

contract at different rates and separate.

Alternatively, the parts can be mechanically separated from the build platform by force using a

tool with a stiff thin blade such as a putty knife. Make certain you do not mark the platform.

For more information on how to clean parts, refer to the VisiJet Material Handling Guide.

Empty Waste Drawers

Personal protection equipment is required before opening waste drawer. Follow all material

handling and disposal guidelines. Always follow Global Health and Safety guidelines and

local regulations regarding handling and disposal of regulated materials. Keep disposal

records if local law requires.

CAUTION: Wear protective gloves before removing any waste material. Be careful not to

spill, drop, or expose others to these materials. Dispose the material according to your local

regulatory guidelines.

NOTE: When removing the draped portion of the bag, be careful not to spill the

material that may be on the top portion of the bag.

1. Open the upper left and upper right MDMs.

2. Slide both waste drawers completely out of the printer.

3. Remove

waste bags

Replace

the plastic

5. Close waste drawers and press the

Standby and Conserve Mode

infocenter.3dsystems.com/projetmjp5500x/print/book/export/html/966

from waste drawers and place into a hazardous waste container.

waste bag

for each drawer.

Start

to resume.

Quick Start Guide

11/13