3d-printz Mini Sinbad 1200 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} 3d-printz Mini Sinbad 1200. 3d-printz Mini Sinbad 1200 6 pagina's.

glue HorStab top onto the rudder. Pay attention to the correct alignment, the part has a

small shoulder which has to be glued to the rudder, but not to the tail unit. It is best to fix

the part with some adhesive tape before gluing and check the ease of movement of the

rudder - it should movable absolutly free. For the attachment of the horizontal stabilizer 2

pcs. 2mm carbon rods are required (see page 1). First glue HorStabR2 with HorStabR1,

then insert the rods and then connect the right half of the tail unit with VertStab so that you

have the right side of the tail unit ready. Then push HorStabL1 onto the bars and check

whether the connecting pieces between the two tail unit halves lock into each other proper

- this is essential so that the elevator can move properly later. Now glue HorStabL1 with

VertStab and HorstabR1 (make sure that the connector between the oars is firmly and,

above all, connected straight with thick superglue!)

After the last part of HorStabL2 has been glued to the

rest of the horizontal stabilizer, you can continue with

the wings.

Next, connect VertStab to Fus4 - you need a

carbon rod with a diameter of 3mm and a

length of

105mm. First

carefully check

the stick for fit,

then join Fus4

and VertStab

with superglue

make sure that

the alignment

is correct - here you can orientate yourself

on the Bowden cable housings. As soon as

the glue has dried (use activator!) You can