Acoustic Remedy ClimaCab Installatie en gebruik - Pagina 6

Blader online of download pdf Installatie en gebruik voor {categorie_naam} Acoustic Remedy ClimaCab. Acoustic Remedy ClimaCab 10 pagina's.

A C O U S T I C R E M E D Y

C L I M A C A B

S E T

U P

A N D

U S E

SET UP AND USE DIRECTIONS

7.) continued....

magnetically lock them to the rails permanently affixed to the floor of the ClimaCab. Move the rails

inward and outward to the proper position relative to one another.

For the ProHang Display/Storage Option, follow the instructions for the Top Rail and then when

the String Swing hangers into the slat wall, locate the small lip on the upper edge of the black

plate. Tilt the hanger slightly from vertical and insert the lip into the opening between the slats.

8.) Once the hangers are inserted, put them into the approximate location along the Top Rail, Neck

Wedge Rail, or Slat Wall based on the instruments you plan to store.

9.) Remove the humidifier reservoir from the box and place into the recessed portion in the floor of

the ClimaCab. The orientation of the humidifier reservoir should be such that the fill/air flow port is

toward the back for the ClimaCab. The fill/air flow port is located opposite of the fan and will

come with a slotted cover plate inserted into the hole.

10.) Thread the black wire inside the recessed box onto the nut on the side of the reservoir. The

wire will have 4 prongs on the end that must line up with the four holes on the reservoir side. Plug

in the cord leaving the back of the ClimaCab (which is from the power supply strip mounted inside

the humidifier box) into a standard outlet. Ensure that the light on the power strip is illuminated by

looking for the orange indicator light. If not, turn on power strip. Ensure the LED light strip and

humidifier power supplies are plugged into the power strip. Once the power strip is plugged in, the

LED light strip will be illuminated and the humidifier control box mounted to the rear center of the

cabinet will illuminate. It will automatically enter Standby mode for 10 minutes. Hold the menu

button and up arrow simultaneously to bypass Standby mode.

11.) Fill the humidifier to the max fill line with distilled water. NOTE: you can fill the reservoir with

less water until the warning on the control box stops flashing.. Once the desired amount of water is

inside the reservoir, you can opt to replace the slotted fill/air port cover plate or leave it out. Under

most circumstances, you'll want to leave the cover plate off. This is designed to be used during

higher humidity situations where passive evaporation is a concern and also when restricting air

flow would be beneficial. NOTE: The Neck/Bout Rest Storage/Display Option comes

automatically with a funnel and tube system to fill the humidifier without have to remove the Bout

Rails. Also, it's recommended to add a few drops of bacteriostat to each fill of the humidifier

reservoir to keep bacteria and mold growth from occurring.