3Doodler Flow Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 3Doodler Flow. 3Doodler Flow 9 pagina's.

6.
I reversed the
plastic but can't
get it out
7.
My Pen won't
heat up (LED
light stays red)
8.
My pen resets
every time I try
to use it.

SECTION 4: TIPS AND BEST PRACTICES

SECTION 4: TIPS AND BEST PRACTICES
Pay attention
to filament types
and settings
11/2023
It is possible that the plastic is either too short to reverse
all the way out of your pen, or that the plastic has moved
past the pen's drive gear system.
You can check for these issues by looking through the
maintenance cover.
Plastic reversed, but is too short to take out and is no longer
in contact with the drive gear.
Plastic is beyond drive gear.
For both of these issues, you can try the
following options:
7A.
While the pen is ON and extruding, insert a
new spool of plastic or use the included tool
to push the remaining plastic through
nozzle tip.
It takes around 60-90 seconds for your pen to heat up. If, after that time,
the pen still does not heat up and the LED light remains RED, turn the
Pen OFF and back ON and try again. If that still does not work, please
contact us at [email protected] and we will assist further.
Check your power source. This pen won't work with smart adapters.
(Adapters that can handle multiple wattages) including USB-C ports
on computers.
• For optimal Doodling, we suggest using the correct temperature settings for
your plastic.
• Double check which type of plastic you are using before you set your pen to
the correct temperature setting (PLA or ABS). If your plastic spools get mixed
up, here is a handy table for sorting and identifying what you're working with.
• For more detailed information on filament types, visit our FAQ:
learn.the3Doodler.com/faqs/.
PLA:
Temp:
PLA Temp
LED Light:
GREEN
Feature:
Glossy plastic sticks to fabric,
windows, metal and other hard surfaces.
How to tell:
Very rigid, no white semi-
circle ends.
SECTION 3: TROUBLESHOOTING
SECTION 3: TROUBLESHOOTING
7B.
While using the
reverse feature,
remove the nozzle
and use the
unblocking tool to
push the plastic out
the back of the pen.
Section 3,
(See
Step
3B)
the
ABS:
Temp:
ABS Temp
LED Light:
BLUE
Feature:
Extruded plastic has a matte
finish. Great for drawing in the air.
How to tell:
Plastic has white semi-
circle ends.
7
EN