AIMS PWRINV800W Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AIMS PWRINV800W. AIMS PWRINV800W 6 pagina's. 800 watt power inverter

Pagina afdrukken

• Coil the television power cord and the input cables running from the 12-volt

power source to the inverter.

• Attach an AC interference filter or similar product between the inverter and the

television power cord. These filters are available at most electronic supply

stores, including Radio Shack.

Note: Inexpensive sound systems may emit a "buzzing" sound when

operated with an inverter. This is due to the inadequate filters in the sound

system. There is no solution to this problem other than purchasing a sound

system with a higher quality power supply or sometimes a pure sine

wave inverter may minimize the interference.

In Review

• Never attempt to operate the inverter from any other power source other than

a 12-volt battery.

• The inverter is designed to be connected to the power source with the supplied

battery cables with battery clips. Do not attempt to modify the battery cables

or clips in any way.

• When connecting and using the inverter, make sure that the inverter is

positioned far away from any potential source of flammable fumes or gases.

• Make certain that the power consumption of the equipment you wish to

operate is compatible with the capacity of the inverter. Do not exceed

800-watts.

• When attempting to operate battery chargers, monitor the temperature of the

battery charger for approximately 10 minutes. If the battery charger becomes

abnormally warm, disconnect it from the inverter immediately.

• Use only 35 amp spade type fuses for the inverter.

• When operating the inverter with an automobile or marine battery, start the

engine every 30 to 60 minutes and let it run for approximately 10 minutes to

recharge the battery.

• In the event of a continuous audible alarm or an automatic shut down of the

unit, turn the inverter OFF immediately. Do not turn the inverter ON again

until the source of the problem has been identified and corrected.

• To avoid battery drain, always disconnect the inverter when not in use.

• Do not expose the inverter to rain or moisture.

• Avoid placing the inverter near sources of heat or in direct sunlight.

• While in use, make sure that the inverter is properly ventilated.

• For best operating results, make sure the unit is placed on a flat surface.

Power Inverter 800W

Troubleshooting

PROBLEM: TV Interference

Reason

Electrical interference from

the inverter.

PROBLEM: Low Battery Alarm On All The Time

Reason

Input voltage below 10.5 ± 0.5 volts.

Poor or weak

battery condition.

Inadequate power being

delivered to the inverter

or excessive voltage drop.

PROBLEM: TV Does Not Work

Reason

TV does not turn on.

Owner's Manual

Solution

Add an AC interference filter on

to the TV power cord. Refer

to TV and audio section of

this manual.

Solution

Keep input voltage above 10.5±0.5

volts to maintain regulation.

Recharge or

replace battery.

Make sure connection is secure.

Use lower gauge wire. Keep

wire length as short as possible.

Solution

Try turning the inverter

ON/OFF/ON.

Contact TV manufacturer for

start up surge and power

consumption.

A larger inverter may

be required.