AIMS PWRINV800W Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Falownik AIMS PWRINV800W. AIMS PWRINV800W 6 stron. 800 watt power inverter

AIMS PWRINV800W Instrukcja obsługi
• Coil the television power cord and the input cables running from the 12-volt
power source to the inverter.
• Attach an AC interference filter or similar product between the inverter and the
television power cord. These filters are available at most electronic supply
stores, including Radio Shack.
Note: Inexpensive sound systems may emit a "buzzing" sound when
operated with an inverter. This is due to the inadequate filters in the sound
system. There is no solution to this problem other than purchasing a sound
system with a higher quality power supply or sometimes a pure sine
wave inverter may minimize the interference.
In Review
• Never attempt to operate the inverter from any other power source other than
a 12-volt battery.
• The inverter is designed to be connected to the power source with the supplied
battery cables with battery clips. Do not attempt to modify the battery cables
or clips in any way.
• When connecting and using the inverter, make sure that the inverter is
positioned far away from any potential source of flammable fumes or gases.
• Make certain that the power consumption of the equipment you wish to
operate is compatible with the capacity of the inverter. Do not exceed
800-watts.
• When attempting to operate battery chargers, monitor the temperature of the
battery charger for approximately 10 minutes. If the battery charger becomes
abnormally warm, disconnect it from the inverter immediately.
• Use only 35 amp spade type fuses for the inverter.
• When operating the inverter with an automobile or marine battery, start the
engine every 30 to 60 minutes and let it run for approximately 10 minutes to
recharge the battery.
• In the event of a continuous audible alarm or an automatic shut down of the
unit, turn the inverter OFF immediately. Do not turn the inverter ON again
until the source of the problem has been identified and corrected.
• To avoid battery drain, always disconnect the inverter when not in use.
• Do not expose the inverter to rain or moisture.
• Avoid placing the inverter near sources of heat or in direct sunlight.
• While in use, make sure that the inverter is properly ventilated.
• For best operating results, make sure the unit is placed on a flat surface.
Power Inverter 800W
7

Troubleshooting

PROBLEM: TV Interference
Reason
Electrical interference from
the inverter.
PROBLEM: Low Battery Alarm On All The Time
Reason
Input voltage below 10.5 ± 0.5 volts.
Poor or weak
battery condition.
Inadequate power being
delivered to the inverter
or excessive voltage drop.
PROBLEM: TV Does Not Work
Reason
TV does not turn on.
Owner's Manual
Solution
Add an AC interference filter on
to the TV power cord. Refer
to TV and audio section of
this manual.
Solution
Keep input voltage above 10.5±0.5
volts to maintain regulation.
Recharge or
replace battery.
Make sure connection is secure.
Use lower gauge wire. Keep
wire length as short as possible.
Solution
Try turning the inverter
ON/OFF/ON.
Contact TV manufacturer for
start up surge and power
consumption.
A larger inverter may
be required.
8