Diy Track Defender Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diy Track Defender. Diy Track Defender 18 pagina's. Vehicle tracker and alarm

Pagina afdrukken

Diagram

Wiring

Cenral Locking Actuator

Refer to your vehicle/owners manual to con rm if the vehicle central locking

actuator is a positive trigger or a negative trigger.

If your actuator is a POSITIVE trigger then connect the PIN 4 Green cable/wire

to the signal cable/wire of the actuator

If your actuator is a NEGATIVE trigger then connect the PIN 8 Blue cable/wire

to the signal cable/wire of the actuator

Power cut relay

This connection is to remotely immobilise your vehicle. Please be cautious if installing

this optional immobiliser function as large currents are carried when starting the vehicle

and we would hate for you to have an unplanned vehicle stop due to an installation failure.

Connect Pin7 yellow wire/cable to the yellow wire/cable (86) of the relay

Connect the white wire/cable (85) of the relay to a constant 12/24v source

Cut the positive wire of the vehicle ignition coil / fuel pump / solenoid etc

Connect the green wire of the relay (30) to one end of the positive wire that you cut

Connect the green wire of the relay (87a) to one end of the positive wire that you cut

WARNING

1 2 3 4 5

6 7 8 9 10

Pin4 Green

Pin8 Blue

(Optional connection)

Solder and insulate all connections (Crimping should be avoided wherever possible)

Pin7 Yellow

Pin3 White

10amp fuse

Pin1 Red

Pin6 Black

Pin5 White with Black = Future use

Pin9 & 10 Red/Black

Pin2 Orange

Relay

87a

+12/24v

Ignition Coil

Fuel Pump

Solenoid

Panic Button

Siren

87a

Relay